Dell OptiPlex 390 Owners Manual - Page 80

WARNING: Dell's Disk Monitoring System, your support desk or Dell - 3 monitors

Get Dell OptiPlex 390 PDF manuals and user guides View all Dell OptiPlex 390 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 80 highlights

Error Message Description a particular sector on the disk, or the requested sector is defective. Requested sector not found The operating system cannot read from the hard drive, the computer could not find a particular sector on the disk, or the requested sector is defective. Reset failed The disk re-set operation failed. Sector not found The operating system cannot locate a sector on the hard drive. Seek error The operating system cannot find a specific track on the hard drive. Shutdown failure A chip on the system board might be malfunctioning. Time-of-day clock stopped The battery might be dead. Time-of-day not set-please run the System The time or date stored in System Setup Setup program does not match the computer clock. Timer chip counter 2 failed A chip on the system board may be malfunctioning. Unexpected interrupt in protected mode The keyboard controller may be malfunctioning or a memory module may be loose. WARNING: Dell's Disk Monitoring System During initial startup, the drive detected has detected that drive [0/1] on the possible error conditions. When your [primary/secondary] EIDE controller is computer finishes booting, immediately operating outside of normal specifications. back up your data and replace your hard It is advisable to immediately back up your drive (for installation procedures, see data and replace your hard drive by calling "Removing and Installing Parts" for your your support desk or Dell computer type). If no replacement drive is immediately available and the drive is not the only bootable drive, enter System Setup and change the appropriate drive setting to None. Then remove the drive from the computer. Write fault The operating system cannot write to the hard drive. Write fault on selected drive The operating system cannot write to the hard drive. 80

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
Error Message
Description
a particular sector on the disk, or the
requested sector is defective.
Requested sector not found
The operating system cannot read from
the hard drive, the computer could not find
a particular sector on the disk, or the
requested sector is defective.
Reset failed
The disk re-set operation failed.
Sector not found
The operating system cannot locate a
sector on the hard drive.
Seek error
The operating system cannot find a
specific track on the hard drive.
Shutdown failure
A chip on the system board might be
malfunctioning.
Time-of-day clock stopped
The battery might be dead.
Time-of-day not set-please run the System
Setup program
The time or date stored in System Setup
does not match the computer clock.
Timer chip counter 2 failed
A chip on the system board may be
malfunctioning.
Unexpected interrupt in protected mode
The keyboard controller may be
malfunctioning or a memory module may
be loose.
WARNING: Dell's Disk Monitoring System
has detected that drive [0/1] on the
[primary/secondary] EIDE controller is
operating outside of normal specifications.
It is advisable to immediately back up your
data and replace your hard drive by calling
your support desk or Dell
During initial startup, the drive detected
possible error conditions. When your
computer finishes booting, immediately
back up your data and replace your hard
drive (for installation procedures, see
"Removing and Installing Parts" for your
computer type). If no replacement drive is
immediately available and the drive is not
the only bootable drive, enter System
Setup and change the appropriate drive
setting to
None
. Then remove the drive
from the computer.
Write fault
The operating system cannot write to the
hard drive.
Write fault on selected drive
The operating system cannot write to the
hard drive.
80