Dell OptiPlex GL Service Manual - Page 22
Interrupt Assignments, Table 1-2., Jumper Descriptions - 200
View all Dell OptiPlex GL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Jumper PSWD BIOS RSRVD4 RSRVD3 RSRVD2 RSRVD1 200MHZ 180MHZ Table 1-2. Jumper Descriptions Description Default Setting Password enable/disable. Installed (password feature Jumper installed, activates enabled) password feature. Used for internal Dell debug tool. Not installed (reserved, do not change) Reserved. Not installed (reserved, do not change) Microprocessor speed. Microprocessor speed. Installed if the microprocessor's internal speed is 200 MHz, or else not installed Installed if the microprocessor's internal speed is 180 MHz, or else not installed Interrupt Assignments Table 1-3. Interrupt Assignments IRQ Line Used By/Available IRQ0 Generated by system timer. IRQ1 Generated by keyboard controller to indicate that keyboard's output buffer is full. IRQ2 Generated internally by interrupt controller to enable IRQ8 through IRQ15. IRQ3 and IRQ4 Generated by super I/O controller to indicate that device connected to corresponding serial port requires service (IRQ3 for COM2 or COM4; IRQ4 for COM1 or COM3). IRQ5 Available for use by expansion card unless this IRQ line is used by secondary parallel port. IRQ6 Generated by super I/O controller to indicate that diskette or tape drive requires service. IRQ7 Generated by super I/O controller to indicate that device connected to parallel port requires service. 1-14 Dell OptiPlex GXpro Systems Service Manual