Dell OptiPlex GL Service Manual - Page 67
Terminator or Add-In Card, Terminator Card
View all Dell OptiPlex GL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Terminator or Add-In Card The system unit may have a terminator card or a secondary microprocessor (dual-processing systems) on an add-in card installed on the system board. This section describes removing and replacing the terminator card and the add-in card. Terminator Card handle terminator card Figure 4-23. Terminator Card Removal To remove a terminator card, follow these steps: 1. Grasp the small white "handle" installed on the top of the card. If a handle is not installed, use the handle that is in the upgrade kit with the secondary microprocessor. Fit the handle over the top of the card so that the nubs of the handle fit through two holes in the top of the card. 2. Pull straight up on the card to free it from the connector. Removing and Replacing Parts 4-23