Dell Precision R5400 Remote Access Device: Administrator's User Manual& - Page 66
Enable Auto-Reconnect, 3.4.4 Session Timeout, 3.5.1 Device Bandwidth Limit
View all Dell Precision R5400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
TERA1x00 PC-over-IP Administrative Interface User Manual TER0606004 Issue 3 Peer FQDN Peer MAC Address Peer FQDN PC-over-IP Used with Portal RDP client only 2.3.4.3 Enable Auto-Reconnect The Enable Auto-Reconnect option allows the Portal to automatically reconnect with the last connected Host after a power-cycle. 2.3.4.4 Session Timeout The Session Timeout configures the timeout for a connection. If the timeout period elapses without the PC-over-IP processor detecting a network, the PC-over-IP processor will disconnect the session. 2.3.5 Bandwidth The Bandwidth tab allows limiting the Portal bandwidth. Note: The Bandwidth can also be configured using the Webpage Administration Interface. See Section 1.5.5 Bandwidth. Figure 45: Bandwidth 2.3.5.1 Device Bandwidth Limit The Device Bandwidth Limit parameter defines the maximum bandwidth for the PC-over-IP system. The Bandwidth setting on the Portal side defines the bandwidth from the Portal to Host (e.g. USB data). Although the maximum bandwidth may be configured, the PC-over-IP system will continue to use only the bandwidth required up to the Device Bandwidth maximum. © 2008 Teradici Corporation Page 66 of 111