Dynex DX-37L200A12 User Manual (English) - Page 15

Making connections DX-32L200A12/DX-37L200A12/DX-46L262A12 11 Connecting an antenna or cable TV (no box) To connect an antenna or cable TV (no box): 1 Turn off your TV and all connected equipment. 2 Connect a coaxial cable (not provided) to the ANT/CABLE IN jack on the side of your TV and to the antenna or cable TV wall jack. Side of TV SE RV IC E PO RT COMPONENT IN R AUDIO PR L AV IN PB COAXIAL Y/ V ID EO HDMI 1 AV IN AV IN Connecting a DVD or Blu-ray player To connect a DVD or Blu-ray player: 1 Make sure that your TV's power cord is unplugged and the DVD or Blu-ray player is turned off. 2 Connect an HDMI cable (not provided) to the HDMI1 or HDMI2 jack on the side of your TV and to the HDMI OUT jack on the DVD or Blu-ray player. Side of TV SE RV IC E PO RT COMPONENT IN R AUDIO PR L AV IN PB COAXIAL Y/ V ID EO HDMI 1 HDMI 2 HDMI 2 ANT/ CABLE IN ANT/ CABLE IN Coaxial cable 3 Turn on your TV, then go through the setup wizard on page 15. Notes • • • Use a coaxial cable to eliminate interference and noise from radio waves. Do not bundle the coaxial cable with the power cord or other cables. If the antenna is not installed correctly, contact qualified service personnel to correct the problem. DVD or Blu-ray player HDMI cable To play from a DVD or Blu-ray player: 1 Turn on your TV, then press INPUT to open the INPUT SOURCE list. 2 Press or to select HDMI 1 or HDMI 2, then press ENTER. Note You can also press HDMI repeatedly to select HDMI1 or HDMI2. 3 Turn on the DVD or Blu-ray player, then set it to the output mode. See the documentation that came with the device for more information.