Epson TM-U950P Specifications - Page 140

APPENDIX D: ADJUSTING THE PAPER ROLL NEAR-END SENSOR LOCATION The remaining detectable amount of paper on the paper roll varies with the inside and outside diameters of the paper core . The minimum detectable amount of paper on the paper roll can be set using the following method: 1) The inside diameter (Æd) of the paper spool should be 10mm (.394") or more. 2) Set the paper roll diameter A to obtain the corresponding adjustment position from the table below. A Approx. 10mm (.39”) Approx. 8mm (.32”) Approx. 6mm (.24”) Approx. 4mm (.16”) Approx. 2mm (.08”) Adjustment position #1 #2 #3 #4 #5 NOTES: 1. Since diameter A corresponding to the adjustment position in the table is calculated values, there may be some variations depending on the printer. 2. If a paper roll with a red end mark at the paper end is used, the mark may cause the paper to pull up. If this occurs, diameter A differs from the values in the table. 3. Be sure that the adjustable slider operates smoothly after finishing the adjustment. 4. If the paper on the paper roll becomes loose due to the paper quality, the paper roll nearend sensor may operate incorrectly. TITLE EPSON TM-U950/U950P Specification (STANDARD) SHEET REVISION NO. NEXT A App.6 SHEET App.5