Epson TM-U950P Specifications - Page 32
Configuration
View all Epson TM-U950P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
2. CONFIGURATION 2.1 Interface 2.1.1 RS-232 serial interface 1) Specifications Data transmission: Serial Synchronization: Asynchronous Handshaking: DTR/DSR or XON/XOFF control Signal levels: MARK = -3 to -15 V: Logic "1" SPACE = +3 to +15 V: Logic "0" Stop bits: 1 or more Connector (printer side): Female DSUB-25 pin connector The data word length, baud rate, and parity depend on the DIP switch settings. (Refer to Section 3.3.3.) 2) Switching between on-line and off-line The printer does not have an on-line/off-line switch. The printer goes off-line: ù Between when the power is turned on (including reset using the interface) and when the printer is ready to receive data ù During the self-test ù When the cover is open ù During paper feeding using the paper feed switch ù When the printer stops printing due to a paper-end (if enabled by ESC c 4) ù When an error has occurred 3) Interface connector terminal assignments and signal functions are described in Table 2.1.1. TITLE EPSON TM-U950/U950P Specification (STANDARD) SHEET NO. REVISION A NEXT 164 SHEET 153