Epson TM-U950P Specifications - Page 23

Ä Copy capability and paper thickness: ùNormal paper (single-ply): 0.09 to 0.2 mm (.0035 to .0079") ùCarbon copy paper combination: 5 sheets maximum (original + 4 copies, at 20° to 40°C (68° to 104°F)) Backing paper: 0.06 to 0.15 mm (.0023 to .0059") Copy and original: 0.04 to 0.07 mm (.0015 to 0028") Carbon paper: Approximately 0.035 mm (.0014") Total thickness: 0.30 mm (.0118") or less (for any combination from a single original to an original + 3 copies) 0.36 mm (.0141") or less (for any combination from a single original to an original + 4 copies) ùPressure sensitive paper: 5 sheets maximum (original + 4 copies, at 20° to 40°C (68° to 104°F)) Backing paper: 0.06 to 0.15 mm (.0023 to .0059") Copy and original: 0.06 to 0.075 mm (.0023 to .003") Total thickness: 0.24 mm (.0094") or less (original to original + 3 copies) 0.30 mm (.0118") or less (original + 4 copies) NOTE: When using multi-ply paper that consists of an original and three copies, be sure to print with a 9 ´ 9 font. If a 7 ´ 9 font is used, some characters on some of the copies may not be readable. c) Check paper (only when the printer is used with the MICR reader) À Paper type: Normal paper Á Total thickness: 0.09 to 0.2 mm (.0035 to .0079") Â Size: 68 to 102 mm ´ 152 to 210 mm (2.68 to 4.02" ´ 2.98 to 8.27") Ã Weight: 70 to 90 kg paper 5) Notes on setting the print operation mode ù The GS E command sets print mode (printing speed and print head energizing time). ù When the power is turned on, normal mode is selected as the default. The printer automatically switches from normal mode to copy mode when slip is selected by ESC c 0. ù Refer to ESC c 0 and GS E. 6) Notes on slip paper ù The slip paper must be flat, without curls or wrinkles, especially at the top edges. Otherwise, the paper may rub against the ribbon and become dirty. ù There must be no glue on the bottom edge of slip paper. It is desirable for the glue to be on the top edge. Choose slip paper carefully when the glue is on the right or left edge, since paper feeding and insertion are affected by gluing conditions (e.g., glue quality, method, and length) and glue location (refer to Figure 1.8.1). Be especially careful when slip paper is wide and has the glue on the right or left edge, since skew may occur. ù Since the slip insertion sensor uses a photo sensor, do not use paper that has holes at the sensor position, or is translucent (refer to Figure 1.8.2). TITLE EPSON TM-U950/U950P Specification (STANDARD) SHEET NO. REVISION AB NEXT 67-1 SHEET 6