Foxconn Inferno Katana English Manual. - Page 117
Copy Create RAID in BIOS.
View all Foxconn Inferno Katana manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
2. Copy section 5-2, BIOS Configuration. Shut down the computer, connect SATA hard disks to SATA ports, power on computer again. Press key, get into BIOS, set "SATA Mode" to [RAID], press to save and exit BIOS. PC will reboot. CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc. IDE Configuration IDE Configuration Help Item Configure SATA as RAID SATA#1 IDE Configuration Compatible SATA#2 IDE Configuration Enhanced ► Primary IDE Master Not Detected ► Primary IDE Slave Not Detected ► Secondary IDE Master Not Detected ► Secondary IDE Slave Not Detected ► Third IDE Master Not Detected ► Fourth IDE Master Not Detected Options IDE RAID AHCI Disabled Hard Disk Write Protect IDE Detect Time Out ATA(PI) 80Pin Cable Detect Disabled 35 Host & Device Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help F9:Optimized Defaults 3. Copy section 5-3, Create RAID in BIOS. Press simultaneously to get into RAID BIOS set up (Intel® Matrix Storage Manager utility). Configure your new hard disks to RAID0, 1, 5 or 10. Exit RAID BIOS. PC will reboot. 4. The Windows XP is running again and a new hardware of RAID disk was found. Click [Cancel] to skip this Wizard. 5 Click to exit. 110