Foxconn Inferno Katana English Manual. - Page 38

Advanced BIOS Features CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc. Advanced BIOS Features Advanced Settings Help Item ► IDE configuration ► AHCI Configuration ► MPS Configuration PPrreessss EEnntteerr Press Enter Press Enter Configure the IDE device(s). 3 Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help F9:Optimized Defaults ► IDE Configuration/ACHI Configuration/MPS Configuration Press to go to relative submenu. IDE Configuration CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc. IDE Configuration IDE Configuration Help Item Configure SATA as IIDDEE SATA#1 IDE Configuration Compatible SATA#2 IDE Configuration Enhanced ► Primary IDE Master Not Detected ► Primary IDE Slave Not Detected ► Secondary IDE Master Not Detected ► Secondary IDE Slave Not Detected ► Third IDE Master Not Detected ► Fourth IDE Master Not Detected Options IDE RAID AHCI Disabled Hard Disk Write Protect IDE Detect Time Out ATA(PI) 80Pin Cable Detect Disabled 35 Host & Device Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help F9:Optimized Defaults ► Configure SATA as This item is used to set the operation mode of your SATA ports 1, 2, 3, 4, 5, 6. Setting values are: [IDE]; [RAID]; [AHCI]; [Disabled]. [IDE] - This configures the SATA ports to support IDE mode. [RAID] - When you enable RAID, it means all your SATA drives must also support AHCI. [AHCI] - The Advanced Host Controller Interface (AHCI) specification describes the register level interface for a Host Controller for Serial ATA. The specification includes a description of the hardware/software interface between system software and the host controller hardware. 31