HP 2000fc Hp StorageWorks 2000 Family Modular Smart Array CLI reference guide - Page 257
show enclosure-status, show events, show expander-status, show frus
View all HP 2000fc manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 257 highlights
show enclosure-status Shows the status of system enclosures and their components. For each attached enclosure, the command shows general SCSI Enclosure Services (SES) information followed by component-specific information. For details see "show enclosure-status" on page 178. show events Shows events for an enclosure, including events from each Management Controller and each Storage Controller. A separate set of event numbers is maintained for each controller module. Each event number is prefixed with a letter identifying the controller module that logged the event. If SNMP is configured, events can be sent to SNMP traps. For details see "show events" on page 181. show expander-status Note - This command should only be used by service technicians, or with the advice of a service technician. Shows diagnostic information relating to SAS Expander Controller physical channels, known as PHY lanes. For each enclosure, this command shows status information for PHYs in I/O module A and then I/O module B. For details see "show expander-status" on page 184. show frus Shows information for all field-replaceable units (FRUs) in the controller enclosure and in any attached drive enclosures. Some information reported is for use by service technicians. For details "show frus" on page 186. Chapter 4 Troubleshooting Using the CLI 257