HP 600 HP StorageWorks 600 Modular Disk System Maintenance and Service Guide - Page 28

Hard drive drawer bezel

Get HP 600 PDF manuals and user guides View all HP 600 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

2. Remove the hard drive. To replace the component: 1. Fully extend the hard drive lever. 2. Push the hard drive all the way into the drive bay, and then close the lever. Hard drive drawer bezel To remove the component: 1. Power down the MDS600 ("Power down" on page 25). 2. Extend the hard drive drawer (on page 25). 3. To access the screws securing the bezel to the hard drive drawer, remove the hard drives in device bays 2 and 7. For the location of these device bays, see "Device bay ID numbers (on page 58)." CAUTION: To avoid data loss, be sure that the drives are labeled and returned to the same bays they were removed from. IMPORTANT: The screws are different lengths. Be sure to note the location of each screw when removing them. Removal and replacement procedures 28

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
Removal and replacement procedures
28
2.
Remove the hard drive.
To replace the component:
1.
Fully extend the hard drive lever.
2.
Push the hard drive all the way into the drive bay, and then close the lever.
Hard drive drawer bezel
To remove the component:
1.
Power down the MDS600 ("
Power down
" on page
25
).
2.
Extend the hard drive drawer (on page
25
).
3.
To access the screws securing the bezel to the hard drive drawer, remove the hard drives in device bays
2 and 7.
For the location of these device bays, see "Device bay ID numbers (on page
58
)."
CAUTION:
To avoid data loss, be sure that the drives are labeled and returned to the same bays
they were removed from.
IMPORTANT:
The screws are different lengths. Be sure to note the location of each screw when
removing them.