HP 600 HP StorageWorks 600 Modular Disk System Maintenance and Service Guide - Page 32
Hot-plug I/O module
View all HP 600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
2. Remove the fan. CAUTION: For best cooling practices, do not operate the enclosure for extended periods with more than one component or blank removed. When removing an active component permanently, replace it with a blank. To replace the fan, install it into the fan bay and push until it locks into place. Hot-plug I/O module Before removing the component, be sure to do the following: • Verify the status of the I/O module to be replaced by reviewing rear panel LEDs and buttons (on page 56). • Be sure that your configuration can support your actions. If the proper redundancy is not in place, power down the MDS600 before beginning this procedure. To remove the component: 1. Be sure the hard drive drawer is closed all the way. 2. Disconnect the SAS cables. Removal and replacement procedures 32