HP 600 HP StorageWorks 600 Modular Disk System Maintenance and Service Guide - Page 48
To replace the cable management arm, Thread the cables through the opening in the drawer.
View all HP 600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
15. Disconnect the cables. When reconnecting the cables, use the following illustration and table to be sure the cables are properly reconnected. Item 1 2 3 4 5 Description Fan signal cable Red 12V power cable Black GND cable Fan power cable Power signal cable 1. Thread the cables through the opening in the drawer. 2. Remove the cable management arm. To replace the cable management arm: 1. Thread the cables through the opening in the drawer, and then connect them to the backplane board. Removal and replacement procedures 48
Removal and replacement procedures
48
15.
Disconnect the cables.
When reconnecting the cables, use the following illustration and table to be sure the cables are properly
reconnected.
Item
Description
1
Fan signal cable
2
Red 12V power cable
3
Black GND cable
4
Fan power cable
5
Power signal cable
1.
Thread the cables through the opening in the drawer.
2.
Remove the cable management arm.
To replace the cable management arm:
1.
Thread the cables through the opening in the drawer, and then connect them to the backplane board.