HP 600 HP StorageWorks 600 Modular Disk System Maintenance and Service Guide - Page 31

Fan, power down the MDS600 before beginning this procedure.

Page 31 highlights

8. Disconnect the cable from the display board. To replace the component, reverse the removal procedure. Fan IMPORTANT: Configurations using power cord part number 142263-004, located on the power cord label, require that the power cord be removed before removing a fan. Before removing a fan, do the following: • Verify the status of the fan to be replaced by reviewing rear panel LEDs and buttons (on page 56). • Be sure that your configuration can support your actions. If the proper redundancy is not in place, power down the MDS600 before beginning this procedure. To remove the component: 1. Be sure that the hard drive drawer is closed. Removal and replacement procedures 31

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63

Removal and replacement procedures
31
8.
Disconnect the cable from the display board.
To replace the component, reverse the removal procedure.
Fan
IMPORTANT:
Configurations using power cord part number 142263-004, located on the
power cord label, require that the power cord be removed before removing a fan.
Before removing a fan, do the following:
Verify the status of the fan to be replaced by reviewing rear panel LEDs and buttons (on page
56
).
Be sure that your configuration can support your actions. If the proper redundancy is not in place,
power down the MDS600 before beginning this procedure.
To remove the component:
1.
Be sure that the hard drive drawer is closed.