HP 600 HP StorageWorks 600 Modular Disk System Maintenance and Service Guide - Page 40
Power block
View all HP 600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Power block To remove the component: 1. Power down the MDS600 ("Power down" on page 25). 2. Disconnect all cables. 3. Remove all power supplies ("Power supply" on page 34). 4. Remove all fan modules ("Fan" on page 31). 5. Remove all I/O modules ("Hot-plug I/O module" on page 32). 6. Disengage the cable management arm lock from each hard drive drawer: a. Pull the mechanism up and then toward the rear of the chassis to disengage it from the locking plate. b. Slide the cable management arm off the locking plate. 7. Loosen the screw securing the power block to the chassis, press down on the release lever, and then slowly remove the power block. The signal and power cables are still attached. Removal and replacement procedures 40
Removal and replacement procedures
40
Power block
To remove the component:
1.
Power down the MDS600 ("
Power down
" on page
25
).
2.
Disconnect all cables.
3.
Remove all power supplies ("
Power supply
" on page
34
).
4.
Remove all fan modules ("
Fan
" on page
31
).
5.
Remove all I/O modules ("
Hot-plug I/O module
" on page
32
).
6.
Disengage the cable management arm lock from each hard drive drawer:
a.
Pull the mechanism up and then toward the rear of the chassis to disengage it from the locking plate.
b.
Slide the cable management arm off the locking plate.
7.
Loosen the screw securing the power block to the chassis, press down on the release lever, and then
slowly remove the power block. The signal and power cables are still attached.