HP Cisco MDS 9120 Cisco MDS 9000 Family Fabric Manager Configuration Guide, Re - Page 1019

Chapter 50 Configuring iSCSI Configuring iSCSI Send documentation comments to [email protected] Step 1 Step 2 Step 3 Step 4 Step 5 Expand Switches, expand Interfaces and then select FC Logical in the Physical Attributes pane. You see the Interface tables in the Information pane (see Figure 50-20). In Device Manager, choose Interface > Ethernet and iSCSI. You see the Ethernet Interfaces and iSCSI dialog box (see Figure 50-21). Click the iSCSI TCP tab in either Fabric Manager or Device Manager. You see the iSCSI TCP configuration table. Set the QoS field from 1 to 6. Click the Apply Changes icon in Fabric Manager or click Apply in Device Manager to save these changes. iSCSI Routing Modes Cisco MDS 9000 Family switches support multiple iSCSI routing modes. Each mode negotiates different operational parameters, has different advantages and disadvantages, and is suitable for different usages. • Pass-thru mode In pass-thru mode, the port on the IPS module or MPS 14/2 module converts and forwards read data frames from the Fibre Channel target to the iSCSI host frame-by-frame without buffering. This means that one data-in frame received is immediately sent out as one iSCSI data-in PDU. In the opposite direction, the port on the IPS module or MPS 14/2 module limits the maximum size of iSCSI write data-out PDU that the iSCSI host can send to the maximum data size that the Fibre Channel target specifies that it can receive. The result is one iSCSI data-out PDU received sent out as one Fibre Channel data frame to the Fibre Channel target. The absence of buffering in both directions leads to an advantage of lower forwarding latency. However, a small maximum data segment length usually results in lower data transfer performance from the host because of a higher processing overhead by the host system. Another benefit of this mode is iSCSI data digest can be enabled. This helps protect the integrity of iSCSI data carried in the PDU over what TCP checksum offers. • Store-and-forward mode (default) In store-and-forward mode, the port on the IPS module or MPS 14/2 module assembles all the Fibre Channel data frames of an exchange to build one large iSCSI data-in PDU before forwarding it to the iSCSI client. In the opposite direction, the port on the IPS module or MPS 14/2 module does not impose a small data segment size on the host so the iSCSI host can send an iSCSI data-out PDU of any size (up to 256 KB). The port then waits until the whole iSCSI data-out PDU is received before it converts, or splits, the PDU, and forwards Fibre Channel frames to the Fibre Channel target. The advantage of this mode is higher data transfer performance from the host. The disadvantages are higher transfer latency and that the iSCSI data digest (CRC) cannot be used. Note The store-and-forward mode is the default forwarding mode. • Cut-through mode OL-16184-01, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family CLI Configuration Guide 50-33