HP Cisco MDS 9120 Cisco MDS 9000 Family Fabric Manager Configuration Guide, Re - Page 300

CFS Example Using Fabric Manager Chapter 13 Using the CFS Infrastructure Send documentation comments to [email protected] Figure 13-14 Status Change to Running Step 12 Select abortChanges from the Config Action drop-down list for each switch that you enabled for CFS (see Figure 13-15). Figure 13-15 Commit Configuration Changes Note Fabric Manager does not change the status to "pending" if enable is selected, because the "pending" status does not apply until the first actual change is made. Step 13 Click the Apply Changes icon to commit the configuration changes for that feature and distribute the changes through CFS. Note When using CFS with features like DPVM and device alias, you must select commit at the end of each configuration. If the session is locked, you must exit the feature by selecting abort. To configure the master or seed switch for distribution for each feature using Fabric Manager, follow these steps: Step 1 Step 2 Step 3 Step 4 Choose the feature that needs a merge master for CFS. For example, expand Switches, expand Events and select CallHome from the Physical Attributes pane. The Information pane shows that feature including a CFS tab. Click the CFS tab to display the CFS state for each switch in the fabric for that feature. Check the Master column check box for the switch to act as the merge master for this feature. Click the Apply Changes icon to select this switch as master for future CFS distributions. . 13-18 Cisco MDS 9000 Family CLI Configuration Guide OL-16184-01, Cisco MDS SAN-OS Release 3.x