HP Cisco MDS 9120 Cisco MDS 9000 Family Fabric Manager Configuration Guide, Re - Page 1243

Chapter 66 Configuring Fabric Congestion Control and QoS Ingress Port Rate Limiting Send documentation comments to [email protected] Step 1 Step 2 Step 3 Create two more class maps. Assign the class maps to the policy map. Repeat Step 1 through Step 2 on Switch 1 to address return path congestion at both switches. Ingress Port Rate Limiting A port rate limiting feature helps control the bandwidth for individual Fibre Channel ports. Port rate limiting is also referred to as ingress rate limiting because it controls ingress traffic into a Fibre Channel port. The feature controls traffic flow by limiting the number of frames that are transmitted out of the exit point on the MAC. Port rate limiting works on all Fibre Channel ports. The rate limit ranges from 1 to 100% and the default is 100%. Note Port rate limiting can only be configured on Cisco MDS 9100 Series switches, Cisco MDS 9216i switches, and MPS-14/2 modules. This feature can only be configured if the QoS feature is enabled and if this configuration is performed on a Cisco MDS 9100 series switch, Cisco MDS 9216i switch, or MPS-14/2 module. To configure the port rate limiting value using Fabric Manager, follow these steps: Step 1 Expand Switches, expand FC Services and then select QoS in the Physical Attributes pane. The QoS control traffic information is displayed in the Information pane shown in Figure 66-8. The default is the Control tab. Figure 66-8 Quality of Service Control Tab Step 2 Click the Rate Limit tab. You see the information shown in Figure 66-9. OL-16184-01, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family CLI Configuration Guide 66-11