HP Cisco MDS 9120 Cisco MDS 9000 Family Fabric Manager Configuration Guide, Re - Page 807

Chapter 42 Configuring IPv4 and IPv6 Access Control Lists Creating IPv4-ACLs or IPv6-ACLs with the IP-ACL Wizard Send documentation comments to [email protected] Step 4 Step 5 Click Create and then click Close. This creates a new IP-ACL profile. Click the IP-ACL you created and click Rules. After you create an IPv4-ACL or an IPv6-ACL, you can add subsequent IP filters at the end of the IPv4-ACL or the IPv6-ACL if you are using Device Manager. Fabric Manager allows you to reorder existing rules for a profile. You cannot insert filters in the middle of an IPv4-ACL or an IPv6-ACL. Each configured entry is automatically added to the end of a IPv4-ACL or an IPv6-ACL. You see the IP ACL dialog box shown in Figure 42-4. Figure 42-4 IP ACL Profile Dialog Box Step 6 Click Create to create an IP filter. You see the Create IP Filter dialog box shown in Figure 42-5. Figure 42-5 Create IP Filter Dialog Box Step 7 Step 8 Choose either permit or deny for the Action and set the IP Number in the Protocol field. The drop-down menu provides common filtered protocols. Set the source IP address you want this filter to match against and the wildcard mask, or check the any check box to match this filter against any IP address. This creates an IP filter that will check the source IP address of frames. Note The wildcard mask denotes a subset of the IP address you want to match against. This allows a range of addresses to match against this filter. OL-16184-01, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family CLI Configuration Guide 42-7