HP Cisco MDS 9120 Cisco MDS 9000 Family Fabric Manager Configuration Guide, Re - Page 691

Chapter 36 Configuring FICON Configuring FICON Send documentation comments to [email protected] Figure 36-12 Persistent FcIds Tab Step 3 Step 4 Select single in the Mask column and then assign the entire FC ID at once. The single option allows you to enter the FC ID in the ###### format. Click the Apply Changes icon to save these changes. Allowing the Host to Move the Switch Offline By default, hosts are allowed to move the switch to an offline state. To do this, the host sends "Set offline" command (x'FD') to CUP (Control Unit Port). To allow the host (mainframe) to move the switch to an offline state using Fabric Manager, follow these steps: Step 1 Step 2 Choose VSAN > FICON. You see a list of switches under the Control tab in the Information pane. Click the VSANs tab. You see the FICON VSAN configuration information in the Information pane (see Figure 36-13). Figure 36-13 FICON VSANs in Fabric Manager Step 3 Step 4 Step 5 Check the Host Can Offline Sw checkbox to allow the mainframe to move a switch to the offline state. Check the Host Can Sync Time checkbox to allow the mainframe to set the system time on the switch. Click the Apply Changes icon to save the changes. OL-16184-01, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family CLI Configuration Guide 36-21