HP Cisco MDS 9120 Cisco MDS 9000 Family Fabric Manager Configuration Guide, Re - Page 954

Using the FCIP Wizard Chapter 48 Configuring FCIP Send documentation comments to [email protected] Creating FCIP Profiles You must assign a local IP address of a Gigabit Ethernet interface or subinterface to the FCIP profile to create an FCIP profile. You can assign IPv4 or IPv6 addresses to the interfaces. Figure 48-18 shows an example configuration. Figure 48-18 Assigning Profiles to Each Gigabit Ethernet Interface Switch 1 IP router IP address of Gigabit Ethernet interface 3/1 = 10.100.1.25 IP Network IP router Switch 2 IP address of Gigabit Ethernet interface 3/1 = 10.1.1.1 91561 To create an FCIP profile in switch 1, follow these steps: Step 1 Step 2 Step 3 Step 4 Step 5 Step 6 Step 7 Step 8 Step 9 Verify that you are connected to a switch that contains an IPS module. From Fabric Manager, choose Switches > ISLs > FCIP in the Physical Attributes pane. From Device Manager, choose FCIP from the IP menu. Click the Create Row button in Fabric Manager or the Create button on Device Manager to add a new profile. Enter the profile ID in the ProfileId field. Enter the IP address of the interface to which you want to bind the profile. Modify the optional TCP parameters, if desired. Refer to Fabric Manager Online Help for explanations of these fields (Optional) Click the Tunnels tab and modify the remote IP address in the Remote IPAddress field for the endpoint to which you want to link. Enter the optional parameters, if desired. See the Cisco MDS 9000 Family CLI Configuration Guide for information on displaying FCIP profile information. Click Apply Changes icon to save these changes. Creating FCIP Links When two FCIP link endpoints are created, an FCIP link is established between the two IPS modules or MPS-14/2 modules. To create an FCIP link, assign a profile to the FCIP interface and configure the peer information. The peer IP switch information initiates (creates) an FCIP link to that peer switch (see Figure 48-19). 48-16 Cisco MDS 9000 Family CLI Configuration Guide OL-16184-01, Cisco MDS SAN-OS Release 3.x