HP Cisco MDS 9216 Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2( - Page 150
bandwidth (interface
View all HP Cisco MDS 9216 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 150 highlights
bandwidth (interface) Chapter 2 Ethernet Commands Send comments to [email protected] bandwidth (interface) To set the inherited and received bandwidth values for an interface, use the bandwidth command. To restore the default values, use the no form of this command. bandwidth {kbps | inherit [kbps]} no bandwidth {kbps | inherit [kbps]} Syntax Description kbps inherit Informational bandwidth in kilobits per second. Valid values are from 1 to 10000000. (Optional) Specifies the bandwidth inherited from the main interface. Command Default 1000000 kbps Command Modes Interface configuration mode Command History Release 4.0(0)N1(1a) Modification This command was introduced. Usage Guidelines The bandwidth command sets an informational parameter to communicate only the current bandwidth to the higher-level protocols; you cannot adjust the actual bandwidth of an interface using this command. The bandwidth inherit command controls how a subinterface inherits the bandwidth of its main interface. The no bandwidth inherit command enables all subinterfaces to inherit the default bandwidth of the main interface, regardless of the configured bandwidth. If a bandwidth is not configured on a subinterface, and you use the bandwidth inherit command, all subinterfaces will inherit the current bandwidth of the main interface. If you configure a new bandwidth on the main interface, all subinterfaces will use this new value. If you do not configure a bandwidth on the subinterface and you configure the bandwidth inherit command on the main interface, the subinterfaces will inherit the specified bandwidth. In all cases, if an interface has an explicit bandwidth setting configured, then that interface will use that setting, regardless of whether the bandwidth inheritance setting is in effect. Examples This example shows how to configure all subinterfaces off this main interface to inherit the configured bandwidth: switch(config-if)# bandwidth inherit 30000 Cisco Nexus 5000 Series Command Reference 2-2 OL-16599-01