HP Cisco MDS 9216 Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2( - Page 678
wwn vsan, Specifies the WWN for the VSAN. The format is
View all HP Cisco MDS 9216 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 678 highlights
wwn vsan Chapter 8 Fibre Channel Commands Send comments to [email protected] wwn vsan To configure a WWN for a suspended VSAN that has interop mode 4 enabled, use the wwn vsan command. To discard the configuration, use the no form of the command. wwn vsan vsan-id vsan-wwn wwn no wwn vsan vsan-id vsan-wwn wwn Syntax Description vsan-id vsan-wwn wwn Specifies the VSAN ID. The range is 1 to 4093. Specifies the WWN for the VSAN. The format is hh:hh:hh:hh:hh:hh:hh:hh. Command Default None Command Modes Configuration mode Command History Release 4.0(0)N1(1a) Modification This command was introduced. Usage Guidelines This command can succeed only if the following conditions are satisfied: • The VSAN must be suspended. • The VSAN must have interop mode 4 enabled before you can specify the switch WWN for it. • The switch WWN must be unique throughout the entire fabric. • The configured switch WWN must have McData OUI [08:00:88]. Examples The following example shows how to assign a WWN to a VSAN: switch(config)# wwn vsan 100 vsan-wwn 20:64:08:00:88:0d:5f:81 switch(config)# vsan database switch(config-vsan-db)# vsan 100 suspend switch(config-vsan-db)# exit switch(config)# wwn vsan 100 vsan-wwn 20:64:08:00:88:0d:5f:81 Related Commands Command vsan database Description Creates multiple fabrics sharing the same physical infrastructure, assigns ports to a VSAN, turns on or off interop mode, and load balances either per originator exchange or source-destination ID. 8-144 Cisco Nexus 5000 Series Command Reference OL-16599-01