HP Cisco MDS 9216 Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2( - Page 618
fspf dead-interval
View all HP Cisco MDS 9216 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 618 highlights
fspf dead-interval Chapter 8 Fibre Channel Commands Send comments to [email protected] fspf dead-interval To set the maximum interval for which a hello message must be received before the neighbor is considered lost, use the fspf dead-interval command. To revert to the default value, use the no form of the command. fspf dead-interval seconds vsan vsan-id no fspf dead-interval seconds vsan vsan-id Syntax Description seconds vsan vsan-id Specifies the FSPF dead interval in seconds. The range is 2 to 65535. Specifies a VSAN ID. The range is 1 to 4093. Command Default 80 seconds. Command Modes Interface configuration mode Command History Release 4.0(0)N1(1a) Modification This command was introduced. Usage Guidelines This command is not applicable to virtual Fibre Channel interfaces. This value must be the same in the ports at both ends of the ISL. Caution An error is reported at the command prompt if the configured dead time interval is less than the hello time interval. Examples The following example configures the maximum interval of 400 seconds for a hello message before the neighbor is considered lost: switch(config)# interface fc 2/1 switch(config-if)# fspf dead-interval 4000 vsan 1 Related Commands Command show fspf interface show interface fc Description Displays information for each selected interface. Displays an interface configuration for a specified Fibre Channel interface. 8-84 Cisco Nexus 5000 Series Command Reference OL-16599-01