HP Cisco MDS 9216 Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2( - Page 203
spanning-tree loopguard default, Entering the Loop Guard command
View all HP Cisco MDS 9216 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 203 highlights
Chapter 2 Ethernet Commands spanning-tree loopguard default Send comments to [email protected] spanning-tree loopguard default To enable Loop Guard as a default on all spanning tree normal and network ports, use the spanning-tree loopguard default command. To disable Loop Guard, use the no form of this command. spanning-tree loopguard default no spanning-tree loopguard default Syntax Description This command has no additional arguments or keywords. Command Default Disabled. Command Modes Configuration mode Command History Release 4.0(0)N1(1a) Modification This command was introduced. Usage Guidelines Loop Guard provides additional security in the bridge network. Loop Guard prevents alternate or root ports from becoming the designated port because of a failure that could lead to a unidirectional link. Loop Guard operates only on ports that are considered point-to-point links by the spanning tree, and it does not run on spanning tree edge ports. Entering the Loop Guard command, spanning-tree guard loop, for the specified interface overrides this global Loop Guard command. Examples This example shows how to enable Loop Guard: switch(config)# spanning-tree loopguard default Related Commands Command show spanning-tree summary Description Displays information about the spanning tree state. OL-16599-01 Cisco Nexus 5000 Series Command Reference 2-55