HP Cisco MDS 9216 Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2( - Page 692

zoneset (EXEC mode) Chapter 8 Fibre Channel Commands Send comments to [email protected] zoneset (EXEC mode) To merge zone set databases, use the zoneset command. zoneset {distribute | export | import interface {fc slot/port | san-port-channel port-number}} vsan vsan-id Syntax Description distribute export import interface fc slot/port san-port-channel port-number vsan vsan-id Distributes the full zone set in the fabric. Exports the zone set database to the adjacent switch on the specified VSAN. The active zone set in this switch becomes the activated zone set of the merged SAN. Imports the zone set database to the adjacent switch on the specified interface. The active zone set in the adjacent switch becomes the activated zone set of the merged SAN. Configures the interface. Configures a Fibre Channel interface for the specified slot number and port number. Specifies SAN port channel interface. Merges the zone set database of a VSAN on the specified interface. The ID of the VSAN is from 1 to 4093. Command Default None Command Modes EXEC mode Command History Release 4.0(0)N1(1a) Modification This command was introduced. Usage Guidelines You can also enter the zoneset import and the zoneset export commands for a range of VSANs. The zoneset distribute vsan vsan-id command is supported in interop 2 and interop 3 modes, and not in interop 1 mode. Examples The following example imports the zone set database from the adjacent switch connected through the VSAN 2 interface: switch# zoneset import interface fc2/3 vsan 2 The following example exports the zone set database to the adjacent switch connected through VSAN 5: switch# zoneset export vsan 5 8-158 Cisco Nexus 5000 Series Command Reference OL-16599-01