HP Integrity Superdome 2 16-socket HP Integrity Superdome 2 User Service Guide - Page 80
Locally accessing the Onboard Administrator, Logout
View all HP Integrity Superdome 2 16-socket manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
2. At the prompt, enter telnet and then press Enter. For example, telnet 192.168.100.130. 3. Enter a valid user name and press Enter. 4. Enter a valid password and press Enter. The CLI command prompt appears. 5. Enter commands for the Onboard Administrator. 6. To end the remote access telnet session, at the CLI command prompt, enter Exit, Logout, or Quit. Procedure 2 SSH session 1. Using any SSH client application, start a SSH session to the Onboard Administrator. 2. When prompted, enter the assigned IP address or DNS name of the Onboard Administrator, and then press Enter. 3. Enter a valid user name and press Enter. 4. Enter a valid password and press Enter. The CLI command prompt displays. 5. Enter commands for the Onboard Administrator. 6. To end the remote access SSH session, at the CLI command prompt, close the communication software or enter Exit, Logout, or Quit . Locally accessing the Onboard Administrator The Onboard Administrator can be accessed locally through a serial port connector on the rear of the Onboard Administrator module. Use a laptop or another computer as a serial console to communicate with the Onboard Administrator. A laptop or PC connected to the Onboard Administrator serial port requires a null-modem cable. The minimum connection to an external console is pins 2, 3, and 5. 1. Connect a serial cable between the serial port on the computer and the corresponding serial port on the Onboard Administrator module. The following table is for the DB9 serial (RS232) port and shows the pinout and signals for the RS232 connector. The signal direction is DTE (computer) relative to the DCE (modem). Pin Name Signal direction Description 1 CD Data terminal ready 5 GND System ground 6 DSR Request to send 8 CTS