HP ProLiant xw2x220c Remote Graphics Software 5.2.5 User Guide - Page 107
Remote Computer, Local Computer, Enable Remote USB, Connect.
View all HP ProLiant xw2x220c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
Figure 6-14 shows the presence of the USB drive key on the Local Computer before the remote USB attachment is made. Figure 6-14 Prior to remote attachment of the USB drive key Remote Computer Local Computer To connect the USB drive key to a Remote Computer in Directory Mode, perform the following steps: 1. Click the USB tab on the Receiver Control Panel. 2. Click the Enable Remote USB checkbox to enable the remote USB connection. 3. Select the IP address (or hostname) of the Remote Computer, and click Connect. 4. Once connection has been established, remove and re-insert the USB drive key-this step is required to initiate the remote USB attachment. As shown in Figure 6-15, the USB drive key is now attached to the Remote Computer, and is no longer available to the Local Computer. Figure 6-15 After remote attachment of the USB drive key Remote Computer Local Computer Advanced capabilities 107