HP ProLiant xw2x220c Remote Graphics Software 5.2.5 User Guide - Page 143
Receiver Remote Display Window specified by these properties
View all HP ProLiant xw2x220c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 143 highlights
Rgreceiver.IsMatchReceiverPhysicalDisplaysEnabled=bool (0) Rgreceiver.IsMatchReceiverPhysicalDisplaysEnabled.IsMutable=bool (1) If the following conditions are met: 1. This property is enabled. 2. Rgreceiver.IsMatchReceiverResolutionEnabled is enabled (see previous property). 3. Rgreceiver.Session..VirtualDisplay.IsPreferredResolutionEnabled is disabled. Then the Receiver will try to set the layout of the Remote Computer (Sender) physical displays to have the same display layout and resolution as the Receiver displays. If the Sender is unable to match the layout and resolution of the Receiver physical displays, the Receiver will try to just match the Receiver display resolution. For example, if the Receiver has two physical displays in a 1x2 layout and a overall virtual display resolution of 2560x1024 (1280x1024x2), the Receiver will try to set the Sender to the same layout and resolution. If that fails, the Receiver will try to set a single physical display resolution of 2560x1024. If that fails, an error is reported. If the following conditions are met: 1. This property is enabled. 2. Rgreceiver.Session..VirtualDisplay.IsPreferredResolutionEnabled is enabled. NOTE: As noted earlier, Rgreceiver.Session..VirtualDisplay.IsPreferredResolutionEnabled takes precedence over Rgreceiver.IsMatchReceiverResolutionEnabled. Therefore, if the former property is enabled (as listed in paragraph 2 above), the latter property is a "don't care", and its setting is ignored. If the above conditions are met, the Receiver will determine the physical displays that are contained within the Receiver Remote Display Window specified by these properties: Rgreceiver.Session..RemoteDisplayWindow.X Rgreceiver.Session..RemoteDisplayWindow.Y Rgreceiver.Session..VirtualDisplay.PreferredResolutionWidth Rgreceiver.Session..VirtualDisplay.PreferredResolutionHeight. The Receiver will try to set the layout of the Remote Computer (Sender) physical displays to match the physical displays contained in this window. For example, if the Receiver has the following: • Two physical displays in a 1x2 layout • An overall virtual display resolution of 2560x1024 (1280x1024x2) • Rgreceiver.Session..RemoteDisplayWindow.X = 1280 • Rgreceiver.Session..RemoteDisplayWindow.Y = 0 • Rgreceiver.Session..VirtualDisplay.PreferredResolutionWidth = 1280 • Rgreceiver.Session..VirtualDisplay.PreferredResolutionHeight = 1024 Then the Receiver will determine that one physical display with a resolution of 1280x1024 is contained within the window. The Receiver will try to set the layout of the Remote Computer Sender to a single physical display and a resolution of 1280x1024. If the following conditions are met: 1. This property is enabled. 2. Rgreceiver.IsMatchReceiverResolutionEnabled is disabled. 3. Rgreceiver.Session..VirtualDisplay.IsPreferredResolutionEnabled is disabled. Then this property has no affect. RGS properties 143