HP ProLiant xw2x220c Remote Graphics Software 5.2.5 User Guide - Page 177
Remote Graphics Sender, Connection denied!
View all HP ProLiant xw2x220c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 177 highlights
Setup Mode hotkey sequence is invalid. The sequence has been disabled. Connection denied! The iLO remote console is enabled. Unable to connect to Sender: The Receiver was unable to resolve the specified hostname or IP Address. Verify that you entered the value correctly. Unable to connect to Sender: The Receiver resolved the specified hostname or IP address, but cannot connect to the Sender. Verify that the system is accessible on your network and that the Remote Graphics Sender service has been started and is listening on a pubic IP address and is not blocked by a firewall. The Setup Mode hotkey sequence specified using a property either on the command-line or in the property configuration file is invalid, and the property Rgreceiver.Hotkeys.IsMutable is disabled. Therefore, hotkeys have been disabled. The iLO remote console is enabled on the HP Blade Workstation. The Blade must be configured in User Mode before connections are allowed. This is usually indicative of a DNS error. The Receiver was able to look up and resolve the specified hostname or IP address. However, the Receiver was unable to establish a connection to the Sender. There are several possibilities such as the Sender is not installed, the Sender is not running, the Sender is listening on the wrong network interface, or a firewall is blocking the Sender. RGS error messages 177