HP RP7 Hardware Reference Guide HP RP7 Retail System Model 7800 - Page 52

Removing and Installing a Hard Drive

Get HP RP7 PDF manuals and user guides View all HP RP7 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 52 highlights

Removing and Installing a Hard Drive CAUTION: If you are replacing a hard drive, be sure to back up the data from the old drive so that you can transfer the data to the new drive. 1. Turn off the computer properly through the operating system, then turn off any external devices. 2. Disconnect the power cord from the power outlet. CAUTION: Regardless of the power-on state, voltage is always present on the system board as long as the system is plugged into an active AC outlet. You must disconnect the power cord to avoid damage to the internal components of the computer. 3. Slide down the two levers on the upper corners of the rear I/O panel (1) and rotate the cover off (2). 4. Press inward on the buttons located near the bottom sides of the display head's back panel (1) then slide the back panel up and off the display head (2). 46 Chapter 2 Hardware Upgrades

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
Removing and Installing a Hard Drive
CAUTION:
If you are replacing a hard drive, be sure to back up the data from the old drive so that
you can transfer the data to the new drive.
1.
Turn off the computer properly through the operating system, then turn off any external devices.
2.
Disconnect the power cord from the power outlet.
CAUTION:
Regardless of the power-on state, voltage is always present on the system board
as long as the system is plugged into an active AC outlet. You must disconnect the power cord
to avoid damage to the internal components of the computer.
3.
Slide down the two levers on the upper corners of the rear I/O panel (1) and rotate the cover off
(2).
4.
Press inward on the buttons located near the bottom sides of the display head's back panel (1)
then slide the back panel up and off the display head (2).
46
Chapter 2
Hardware Upgrades