HP Surestore 64 HP Surestore Director FC-64 Product Manager User's Guide - Page 191

Using Maintenance Features Reset Configuration Note You must have maintenance authorization rights to access this feature. This feature is used to reset all configuration data for the director to factory default values. Notes Please note that since the internet protocol (IP) address will reset to the factory default value (refer to Table 4) during this procedure, you may not recover the Ethernet connection between the director and HP EFC server if you have changed the director 's IP addressing from that default value. In this case you must re-enter LAN addressing, such as IP and gateway addresses, through a terminal attached to the maintenance port. Before using the reset configuration option, record the director's current IP address, which displays below the switch's icon in the HP EFC Manager's Product View (view Display Options set to Network Address). You can also find the current IP address through the embedded web-server interface. After resetting the configuration, reset LAN addressing to the desired values through the maintenance port or the embedded web-server interface. Use of the maintenance port is not covered in this manual. Refer to the installation chapter in the hp surestore director fc-64 Installation and Service Manual (HP A6534-90902) for procedures. Procedure Use the following steps to reset the configuration parameters on the director to the default values. 1. Select Reset Configuration from the Maintenance menu. The following warning displays: Reset Configuration 175