HP Surestore 64 HP Surestore Director FC-64 Product Manager User's Guide - Page 198
Cancel, Message, Cause/Solution
View all HP Surestore 64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 198 highlights
Message Cause/Solution Cannot run diagnostics on an uninstalled port. Port diagnostics cannot be performed on a port that is not installed. Run diagnostics only on a port that is installed. Cannot run diagnostics while a A device is logged in to the port where a diagnostic test is device is logged-in to the port. attempted. Log out the device and run the diagnostic test again. Cannot save port configuration. Port configuration cannot be saved. The link is down or busy. Retry the operation later. If the condition persists, contact support personnel. Cannot save SNMP configuration. SNMP configuration cannot be saved. The link is down or busy. Retry the operation later. If the condition persists, contact support personnel. Cannot set Fibre Channel parameters. Fibre Channel parameters cannot be set. The link is down or busy. Retry the operation later. If the condition persists, contact support personnel. Cannot set director date and time. Director date and time cannot be set. The link is down or busy. Retry the operation later. If the condition persists, contact support personnel. Cannot set director state. Director state cannot be set. The link is down or busy. Retry the operation later. If the condition persists, contact support personnel. Cannot set write authorization without defining a community name. A community name was not defined in the Configure SNMP dialog box for the write authorization selected. Provide a name in the name field where write authorization is checked. Cannot start data collection. Data collection cannot be started. The link is down or busy. Retry the operation later. If the condition persists, contact support personnel. Cannot start firmware install CTP synchronization is in progress while you are attempting to while CTP synchronization is in install firmware. Wait for the CTP synchronization to complete progress. before starting the firmware install. Cannot start port diagnostics. Port diagnostics cannot be started. The link is down or busy. Retry the operation later. If the condition persists, contact support personnel. Click OK to remove all contents Requesting confirmation that you want all contents removed from log. from the log. Click OK to continue or click Cancel to end the operation. 182 Appendix