Honeywell HW5500E Owners Manual - Page 14
Step 2: Install Wheel Axle and Wheels, To install wheel assembly, you will need
UPC - 894190002025
View all Honeywell HW5500E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Assembly Step 2: Install Wheel Axle and Wheels To install wheel assembly, you will need: Wheel axle (1) M8 x 16 mm long full-thread hex flange bolts (4) M8 serrated flange nuts (4) Axle bracket* (1) Wheels (2) M16 x 30 mm OD x 2 mm washers (2) Cotter pins (2) 13 mm open end wrench† Socket wrench with 13 mm socket† Needle-nose pliers† * Two brackets are needed to install wheel axle. One bracket comes already attached to wheel axle; other bracket is included in wheel kit box. † Not included. 1. Install wheel axle brackets to frame using 16 mm long full-thread hex flange bolts and serrated flange nuts. 1A. Install pre-attached bracket to frame first. 1B. Install other bracket (included in hardware bag) to frame. 3. Slide a washer onto axle. 4. Slide cotter pin into pre-drilled hole until fully seated. 5. Using needle-nose pliers, bend each end of cotter pin in opposing directions to secure wheel to axle. FIGURE 10: Cotter Pin Installation 6. Return generator to upright position (so that wheels and leg supports are touching the ground). FIGURE 8: Wheel Axle Attached to Generator On each end of axle: 2. Slide and push wheel onto axle until it fits snug against washer. FIGURE 9: Slide Wheel onto Wheel Axle NOTE: Axle brackets are offset (one side longer than the other), place with the short side up during installation. 8 www.honeywellgenerators.com HW5500/HW5500E/HW5500EL/HW5500L Portable Electrical Generator Owner's Manual