Husqvarna MADSAW Owner Manual - Page 11

To disassemble the shaft, To assemble the branch hook, To assemble the impact guard

Get Husqvarna MADSAW PDF manuals and user guides View all Husqvarna MADSAW manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

2. Push and hold the release button. 2. Push and hold the release button. 3. Carefully push the shaft into the coupling until you hear a click. Make sure that the release button go into the hole in the coupling. 3. Hold tight to the end of the shaft segments that you are to remove. 4. Pull the shaft straight out of the coupling. 4. Tighten the knob fully. To assemble the branch hook • Use 2 screws to attach the branch hook. To disassemble the shaft 1. Turn the knob 3 turns or more to loosen the coupling. To assemble the impact guard 1. Assemble the guard with 3 screws. 1480 - 009 - 26.01.2022 2. Tighten the screws to 30 ft/lbs (4 Nm). 3. Tighten the screws again when the product has been in use for about 20 hours. 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
2.
Push and hold the release button.
3.
Carefully push the shaft into the coupling until
you hear a click. Make sure that the release
button go into the hole in the coupling.
4.
Tighten the knob fully.
To disassemble the shaft
1.
Turn the knob 3 turns or more to loosen the
coupling.
2.
Push and hold the release button.
3.
Hold tight to the end of the shaft segments that
you are to remove.
4.
Pull the shaft straight out of the coupling.
To assemble the branch hook
•
Use 2 screws to attach the branch hook.
To assemble the impact guard
1.
Assemble the guard with 3 screws.
2.
Tighten the screws to 30 ft/lbs (4 Nm).
3.
Tighten the screws again when the product has
been in use for about 20 hours.
1480 - 009 - 26.01.2022
11