Husqvarna MADSAW Owner Manual - Page 14

CAUTION, To prepare the product for start, WARNING, To start the product

Get Husqvarna MADSAW PDF manuals and user guides View all Husqvarna MADSAW manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

CAUTION: If the oil is too thin, it runs out before the fuel. In temperatures below 0°C/32°F some chain oils become too thick, which can cause damage to the oil pump components. • Use the recommended cutting equipment. Refer to Recommended cutting equipment on page 26. To prepare the product for start 1. Push the air purge bulb 10 times. Note: It is not necessary to fully fill the bulb. 2. Move the choke control up into choke position. WARNING: The saw chain will start to rotate immediately when you start the engine with the choke. To start the product WARNING: Read the warning instructions in the safety chapter before you start the product (refer to Safety on page 4). 1. Use protective gloves. 2. Hold the body of the product on the ground with your left hand. CAUTION: Do not use your feet! 3. Hold the starter rope handle with your right hand. 4. Slowly pull out the starter rope with your right hand until you feel some resistance (the starter pawls grip). WARNING: Do not twist the starter rope around your hand. 5. Pull the cord quickly and with power. CAUTION: Do not pull the starter rope all the way out and do not let go off the starter rope handle when the starter rope is fully extended. This can cause damage to the product. 6. Pull the starter rope until the engine starts or for a maximum of 5 times. 7. Reset the choke when the engine starts or after you pull the starter rope 5 times. 8. If it is necessary, pull the starter rope again and again until the engine starts. 9. Let the engine run for 10 seconds. 10. Operate the throttle gradually. 11. Make sure the engine runs smoothly. Note: If the engine stops, do the procedure again. About the surface WARNING: Do not put parts of your body in the grey marked area. If you touch the grey marked area it can result in burns to the skin. It can also cause electrical shock if the spark plug cap has been damaged. Do not use a product with a damaged spark plug cap. To start a warm engine WARNING: Read the warning instructions in the safety chapter before you start the product (refer to Safety on page 4). 1. Use protective gloves. 14 1480 - 009 - 26.01.2022

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
CAUTION:
If the oil is too
thin, it runs out before the fuel. In
temperatures below 0°C/32°F some
chain oils become too thick, which
can cause damage to the oil pump
components.
•
Use the recommended cutting equipment. Refer
to
Recommended cutting equipment on page
26
.
To prepare the product for start
1.
Push the air purge bulb 10 times.
Note:
It is not necessary to fully fill the bulb.
2.
Move the choke control up into choke position.
WARNING:
The saw chain will
start to rotate immediately when you
start the engine with the choke.
To start the product
WARNING:
Read the warning
instructions in the safety chapter before
you start the product (refer to
Safety on
page 4
).
1.
Use protective gloves.
2.
Hold the body of the product on the ground with
your left hand.
CAUTION:
Do not use your feet!
3.
Hold the starter rope handle with your right hand.
4.
Slowly pull out the starter rope with your right
hand until you feel some resistance (the starter
pawls grip).
WARNING:
Do not twist the
starter rope around your hand.
5.
Pull the cord quickly and with power.
CAUTION:
Do not pull the
starter rope all the way out and
do not let go off the starter rope
handle when the starter rope is fully
extended. This can cause damage to
the product.
6.
Pull the starter rope until the engine starts or for
a maximum of 5 times.
7.
Reset the choke when the engine starts or after
you pull the starter rope 5 times.
8.
If it is necessary, pull the starter rope again and
again until the engine starts.
9.
Let the engine run for 10 seconds.
10. Operate the throttle gradually.
11. Make sure the engine runs smoothly.
Note:
If the engine stops, do the procedure
again.
About the surface
WARNING:
Do not put parts of your
body in the grey marked area. If you
touch the grey marked area it can result
in burns to the skin. It can also cause
electrical shock if the spark plug cap has
been damaged. Do not use a product
with a damaged spark plug cap.
To start a warm engine
WARNING:
Read the warning
instructions in the safety chapter before
you start the product (refer to
Safety on
page 4
).
1.
Use protective gloves.
14
1480 - 009 - 26.01.2022