IBM 43635gu Installation Guide - Page 35
ServeRAID, Support
UPC - 883436002950
View all IBM 43635gu manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Drive-tray assembly Drive tray handle (in open position) To install a hot-swap SAS or hot-swap SATA hard disk drive, complete the following steps: 1. Read the safety information that begins on page v and "Installation guidelines" on page 7. 2. Unlock the side cover. 3. Remove the side cover and lower bezel (see "Removing the side cover" on page 10 and "Removing the two-piece bezel" on page 11). 4. Install the hard disk drive in the hot-swap bay: a. Make sure that the drive tray handle is open. b. Align the drive assembly with the guide rails in the bay. c. Gently push the drive assembly into the bay until the drive stops. d. Push the tray handle to the closed (locked) position. e. Check the hard disk drive status indicator to make sure that the hard disk drive is operating correctly. (You might have to restart the server before the drive is recognized.) If the amber hard disk drive status LED for a drive is lit continuously, it indicates that the drive is faulty and must be replaced. If the green hard disk drive activity LED is flashing, this indicates that the drive is being accessed. Note: If the server is configured for RAID operation using an optional ServeRAID adapter, you might have to reconfigure your disk arrays after installing hard disk drives. See the ServeRAID documentation on the IBM ServeRAID Support CD for additional information about RAID operation and complete instructions for using ServeRAID Manager. 5. If you are installing additional hot-swap hard disk drives, do so now. Chapter 2. Installing optional devices 21