IBM 8486 User Guide - Page 16
Features, specifications - microprocessor
UPC - 000435839718
View all IBM 8486 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Features and specifications The following information is a summary of the features and specifications of the server. Depending on the server model, some features might not be available, or some specifications might not apply. Table 1. Features and specifications Microprocessor: v Intel™ Pentium® 4 or Celeron Processor v 1 MB Level-2 or 256 KB level-2 cache v 800 MHz front-side bus (FSB) or 533 MHz front-side bus Note: Use the Configuration/Setup Utility program to determine the type and speed of the microprocessor. Memory: v Minimum: 256 MB v Maximum: 8 GB v Types: PC2-4200, double-data-rate 2 (DDR2) with ECC v Connectors: four dual inline memory module (DIMM) connectors, two-way interleaved Drives: (depending on your model) v Diskette: (optional) 1.44 MB (two mode) v Hard disk drive: SATA v One of the following IDE drives: - CD-ROM - CD-RW (optional) - DVD-ROM (optional) - DVD/CD-RW combo (optional) Expansion bays: (depending on your model) v Two 5.25-in. bays (one CD or DVD drive installed) v One 3.5-in. removable-media drive bays (optional) v Two 3.5-in. hard disk drive bays (one hard disk drive installed) Expansion slots: v One PCI Express x1 v One PCI Express x8 v Two PCI 32-bit/33 MHz Video controller: ATI ES1000 video controller with 16 MB SDRAM video memory on the system board Fans: Two speed-controlled fans Power supply: One 310 watt (90-240 V Environment: ac) v Air temperature: - Server on: 10° to 35°C (50° to 95°F) Important: Make sure that the ac power Altitude: 0 to 914 m (2998.0 ft) supply input voltage is set to the right level - Server off: 0° to 60°C (-32° to 140°F) (between 110 V ac and 220 V ac) for your Altitude: 0 to 2133 m (7000.0 ft) geographic location before powering on v Humidity (operating and storage): 8% to the system. 80% Size: v Height: 438 mm (17.24 in.) v Depth: 497 mm (19.57 in.) v Width: 205 mm (8.07 in.) v Weight: 14 kg (30.86 lb) to 17 kg (37.48 lb) depending upon configuration Integrated functions: v Broadcom 5721 10/100/1000 Ethernet controller on the system board with RJ-45 Ethernet port v Two serial ports v One parallel port v Two-port Serial ATA controller v Four Universal Serial Bus (USB) v2.0 ports (two on front and two on rear) v Keyboard port v Mouse port v ATA-100 single-channel IDE controller v ATI ES1000 video - Compatible with SVGA and VGA - 16 MB video memory Diagnostic LEDs: v Fans v Memory v Microprocessor Acoustical noise emissions: v Sound power, idling: 5.0 bel v Sound power, operating: 5.5 bel Heat output: Approximate heat output in British thermal units (Btu) per hour v Minimum configuration: 379 Btu (111 watts) per hour v Maximum configuration: 853 Btu (250 watts) per hour Electrical input: v Sine-wave input (50 or 60 Hz) required v Input voltage and frequency ranges manually selected v Input voltage low range: - Minimum: 100 V ac - Maximum: 127 V ac v Input voltage high range: - Minimum: 200 V ac - Maximum: 240 V ac v Input kilovolt-amperes (kVA) approximately: - Minimum: 0.15 kVA (all models) - Maximum: 0.59 kVA Notes: 1. Power consumption and heat output vary depending on the number and type of optional features installed and the power-management optional features in use. 2. These levels were measured in controlled acoustical environments according to the procedures specified by the American National Standards Institute (ANSI) S12.10 and ISO 7779 and are reported in accordance with ISO 9296. Actual sound-pressure levels in a given location might exceed the average values stated because of room reflections and other nearby noise sources. The declared sound-power levels indicate an upper limit, below which a large number of computers will operate. 4 xSeries 100 Type 8486: User's Guide