Icom IC-F8101 Instruction Manual - Page 28
Send Position call, to transmit the Send Position call.
View all Icom IC-F8101 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
4 SELCALL/ALE OPERATION DDSend Position call The Send Position call allows you to send your own position and time information to the intended ID station. • Preparation for a Send Position call Send a Channel Test call on several Selcall channels, and check the propagation on each one to select the channel with the best signal quality. (p. 26) • Sending a Send Position call qqHold down [ ] for 1 second to enter the Network selection screen. wwPush [r] or [s] to select the desired Network, and then push [ ]. • The Networks that belong to the Icom Selcall or Open Selcall systems must be selected. eePush [r] or [s] to select the Call Type to "Send Position." • "Selective," "Phone," "Message," "Send Position," "Get Position," "Get Status," "Emergency," "Channel Test" and "Stun" are selectable. The Get Status call is selectable in the Icom Selcall, and the Stun call is selectable in the Open Selcall. uuPush [ ] to transmit the Send Position call. The call is stored in the Call Out memory. • While calling, push [PTT] to cancel the call. You can also make a Send Position call when the Address screen is displayed. In this case, you can skip several steps, see page 29 for the Simple Selcall operation details. • Receiving Send Position calls When your transceiver receives a Send Position call with your individual ID, it automatically responds by transmitting. The received Selcall is stored in the Call In memory. qqPush [8] to enter the Main Menu screen. wwPush [r] or [s] to select "Call In," and then push [4]. eePush [r] or [s] to select the desired Call, and then push [4]. rrPush keypad to enter the Call ID, and then push [ ]. • The previously entered Call ID is displayed. • Push [t](§) or [u](§§§) to move the cursor. • Push [8] to delete the digit to the left of the cursor. • This Call ID is not stored in the Call ID list. ttPush [r] or [s] to select the Profile, then push [ ]. rrPush [r] or [s] to select the information. ttPush [8] twice to return to the normal operating screen. yyPush [r] or [s] to select the Channel. • Only the channels that belong to the selected Network in step w, are displayed. • If desired, push [Tests](§§) to transmit the Channel Test call in this step. 22