Icom IC-F8101 Instruction Manual - Page 80
■ HM-192 (Optional Remote control microphone), Mounting
View all Icom IC-F8101 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
6 CONNECTION AND INSTALLATION ■ HM-192 (Optional Remote control microphone) The HM-192 allows you to remotely control the transceiver by using the microphone instead of the Front panel*. Use either the optional OPC-607, OPC-608, OPC-609 or OPC-726 separation cable. The HM-192 is the same as the one supplied in the Remote control microphone type transceiver. *When the HM-192 is connected, the Front panel can not be used. r Attach the Extension MIC connector to the desired place, then tighten the 2 supplied screws (M4 × 20 mm). D Mounting The optional OPC-607 (3 m; 9.8 ft), OPC-608 (8 m; 26.2 ft), OPC-609 (1.9 m; 6.2 ft) or OPC-726 (5 m; 16.4 ft) separation cable is required to install the transceiver's Main unit and Remote control microphone. q Unscrew the 4 rear plate screws, then remove the rear plates from both the Extension MIC connector and the Main unit attachment. Rear plate *This illustration shows the description for the Main unit attachment. t Attach the holder base to the desired place near the Extension MIC connector, then tighten the 2 supplied screws (M4 × 20 mm). Main unit attachment w Connect either the OPC-607, OPC-608, OPC-609 or OPC-726 separation cable to the Main unit attachment, as shown below. After connecting the cable, replace the rear plate and the 4 screws. • The separation cable can be inserted into either the left or right grooves on the back of the attachment. Use the supplied M3 × 8 screw. Separation cable Cable groove y Adjust the MIC holder angle, then tighten the one supplied M4 × 14 mm screw. Main unit attachment Rear plate e C onnect the other side of the Separation cable to the Extension MIC connector, as described in step w. After the cable is connected, replace the rear plate and the 4 screws. u Connect the HM-192 to the Extension MIC connector. 74