Icom IC-R75 Instruction Manual - Page 15

4 FREQUENCY SETTING ■ Read me first The receiver uses memory channels for storage of frequencies (as well as mode, tuning steps, etc.). When turning power OFF or changing memory channels, the previously displayed frequency cannot be recalled unless it has been stored into a memory channel. USB R X Therefore, when you want to keep a displayed frequency for later recall, you must program it into a memory channel by pushing [MW] for 2 sec. See p. 22 for details. ANT 1 AGC BLANK S1 3 5 7 9 20 40 60dB VFO "BLANK" appears above the memory channel readout until [MW] is pushed for 2 sec. Push [MW] for 2 sec. after tuning. ■ Using the keypad q P ush the numeral keys on the keypad to enter the MHz digits for the desired frequency. • If a key is mistakenly pushed, push [CLR] and start again from the beginning. • When entering the same MHz digits as the displayed frequency, this step can be skipped. w Push [•] on the keypad. [EXAMPLE]: Setting the frequency using the keypad. e P ush the numeral keys to enter the frequency digits below 1 MHz. • If a key is mistakenly pushed, push [CLR] and start again from the beginning. r Push [ENT] to set the input frequency. • When pushing [ENT] after entering the MHz digits, zeros are automatically entered for the kHz digits. •To set to 28.00 MHz 2 8 ABC TUV ENT USB R X USB R X USB R X •To set to 21.050 MHz 2 ABC 1 . USB R X USB R X 0 5 QZ JKL ENT USB R X USB R X •To set to 850 kHz (0.850 MHz) 0 QZ . 8 5 TUV JKL ENT USB R X USB R X USB R X USB R X •To change 14.19075 to 14.850 MHz . 8 5 TUV JKL ENT USB R X USB R X USB R X USB R X 11