Icom IC-R75 Instruction Manual - Page 45

CONTROL COMMAND 14 • Command table Command Sub command 00 - Same as 01 command 06 02 - 03 - Same as 04 command 06 05 - 00*1 01*1 02*1 03*1 06 04*1 05*1 07*1 08*1 07 - - 08 0001 - 0101*2 09 - 0A - 0B - 00 01 02 04 22 0E 23 B0 B1 D0 D3 00 01 02 03 04 05 10 06 07 08 09 10 11 Description Send frequency data Send mode data Read band edge frequencies Read operating frequency Read operating mode Set frequency data Set LSB Set USB Set AM Set CW Set RTTY Set FM Set CW-R Set RTTY-R *1Add 00, 01 or 02 for selecting wide, normal or narrow filter, respectively. Select VFO mode Select memory mode Select memory channel *2P1=0100, P2=0101 Memory write Memory to VFO Memory clear Scan stop Programmed/memory scan start Programmed scan start Auto memory write scan start Memory scan start Select memory scan start Set as non-select channel Set as select channel Set scan resume OFF Set scan resume ON 10 Hz (1 Hz) tuning step 100 Hz tuning step 1 kHz tuning step 5 kHz tuning step 6.25 kHz tuning step 9 kHz tuning step 10 kHz tuning step 12.5 kHz tuning step 20 kHz tuning step 25 kHz tuning step 100 kHz tuning step 1 MHz tuning step Command Sub command 00 11 20 00 12 01 00 13 01 02 01 + level data 02 + level data 03 + level data 06 + level data 14 07 + level data 08 + level data 09 + level data 01 15 02 02 12 16 22 40 41 18 00 01 19 00 1A 00 + data 01 + data 02 + data Description Attenuator OFF Attenuator ON Select [ANT1] Select [ANT2] Announce with voice synthesizer (00=all data; 01=frequency and S-meter level; 02=receive mode) [AF] level setting (0000=max. CCW to 0255=max. CW) [RF] level setting (0000=max. CCW to 0255=11 o'clock) [SQL] level setting (0000=11 o'clock to 0255=max. CW) [NR] level setting (0000=min. to 0255=max.) Inside [TWIN PBT] setting (0000=max. CCW, 0128=center, 0255=max. CW) Outside [TWIN PBT] setting (0000=max. CCW, 0128=center, 0255=max. CW) [CW PITCH] setting (0000=low pitch to 0255=high pitch) Read squelch condition Read S-meter level Set preamp (00=OFF; 01=preamp 1; 02=preamp 2) Set AGC time constant (00=OFF; 01=S-fast; 02=fast; 03=slow) Set noise blanker (00=OFF; 01=ON) Set optional noise reduction (00=OFF; 01=ON) Set optional auto notch (00=OFF; 01=ON) Turn the receiver power ON Turn the receiver power OFF Read the receiver ID Send/read memory contents (See example 1 on p. 42) Send/read IF filter setting (See example 2 on p. 42) Send/read set mode contents (See example 3 on p. 43) 41