Icom IC-R75 Instruction Manual - Page 26

6 MEMORY OPERATION ■ Memory channel programming Memory channel programming can be preformed either in VFO mode or in memory mode. D Programming in VFO mode q S et the desired frequency and operating mode in VFO mode. w P ush [UP Y] or [Z DN] several times to select the desired memory channel. • "BLANK" appears if the selected memory channel is a blank channel (and does not have contents). e P ush [MW] for 2 sec. to program the displayed frequency and operating mode into the memory channel. • Preamp setting, attenuator on/off, antenna selection, and AGC setting can also be programmed into a memory channel. [EXAMPLE]: Programming 7.088 MHz/LSB into memory channel 12. USB R X ANT 1 AGC S1 3 5 7 9 20 40 60dB VFO SSB LSB or keypad R X ANT 1 AGC S1 3 5 7 9 20 40 60dB VFO UP or DN LSB R X ANT 1 AGC BLANK S1 3 5 7 9 20 40 60dB VFO MW LSB Beep Beep Beep Push for 2 sec. R X ANT 1 AGC S1 3 5 7 9 20 40 60dB VFO D Programming in memory mode q S elect the desired memory channel with [UP Y] or [Z DN] in memory mode. • "BLANK" appears if the selected memory channel is a blank channel (and does not have contents). w S et the desired frequency and operating mode in memory mode. • To program a blank channel, use direct frequency entry with the keypad in advance. e P ush [MW] for 2 sec. to program the displayed frequency and operating mode into the memory channel. • Preamp setting, attenuator on/off, antenna selection, and AGC setting can also be programmed into a memory channel. [EXAMPLE]: Programming 21.280 MHz/CW into memory channel 18. USB R X ANT 1 AGC S1 3 5 7 9 20 40 60dB VFO V/M then UP or DN S1 3 5 7 9 20 40 60dB BLANK MEMO CW/RTTY keypad then CW R X ANT 1 AGC S1 3 5 7 9 20 40 60dB BLANK MEMO Beep MW Beep Push for 2 sec. Beep CW R X 22 ANT 1 AGC S1 3 5 7 9 20 40 60dB MEMO