Icom ID-51A PLUS Instruction Manual - Page 16

1 PANEL DESCRIPTION ■■ Front, top and side panels (Continued) !6 MEMORY/CALL • SELECT MEMORY WRITE KEY [M/CALL•S.MW] ➥ In the VFO mode, push once to enter the Memory selection mode, push again to enter the Call channel mode. (p. 36) For ID-51A only In the Call channel mode, push once to enter the Weather channel mode. ➥ Hold down for 1 second to enter the Select Memory Write mode. (p. 41) !7 VFO/MHz • CLEAR • OUTPUT POWER KEY [VFO/MHz•CLR•LOW] ➥ Push to select the VFO mode. (p. 36) ➥ While in the VFO mode, push to select 1 MHz and 10 MHz tuning steps. (p. 34) ➥ W ith the Menu screen or Quick Menu screen open, push to return to the operating mode before entering the menu screen. ➥ While in the Memory Name or Call Sign Programming mode, push to delete a character. (p. 13) ➥ While scanning, push to cancel a scan. ➥ Hold down for 1 second to select the output power. (p. 38) • S elect the transmit output power of High, Mid, Low2, Low1 or S-low. • W hile holding down this key, rotate [DIAL] to select the desired output power. 3 !8 C S (CALL SIGN SELECT)/D-PAD (RIGHT) KEY [CS]/D-pad() ➥ Hold down for 1 second to enter the operating call sign select mode. ➥ While in the DR screen, or with the Menu screen or Quick Menu screen open, push to select a lower tier menu. !9 RXÚCS (RX CALL SIGN CAPTURE)/D-PAD (UP) KEY [RXÚCS]/D-pad() ➥ H old down for 1 second to set the received call signs (station and repeaters) as the operating call signs. • W hile holding down this key, rotate [DIAL] to select another call sign in RX History. ➥ While in the DR screen, or with the Menu screen or Quick Menu screen open, push to move the value or option selector bar up. @0 E XTERNAL MICROPHONE/SPEAKER JACK [MIC/SP] Connect a cloning cable, optional speaker microphone or headset, if desired. See Section 18 in the Advanced instructions for a list of available options. Be sure to turn OFF the power before connecting or disconnecting optional equipment to or from the [MIC/ SP] jack.