Intel MFSYS25 User Guide - Page 35
Mounting System in Rack, Hot-Swap Module Installation and Removal Guidelines - modular server system review
UPC - 735858196901
View all Intel MFSYS25 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Warning: If using the handles during rack installation, the rear handles must be removed prior to setting the system on the rack rails to avoid interference of the handles with the rack. The front handles must also be removed before sliding the system completely into the rack and securing the front chassis tabs to the rack. Mounting System in Rack Please read the safety information at the beginning of this book before installing the chassis in a rack. Warning: If you have installed temporary handles to aid in moving and/or configuring the system, you must remove the rear handles prior to setting the system on the rack rails to avoid interference of the handles with the rack. The front handles must also be removed before sliding the system completely into the rack and securing the front chassis tabs to the rack. 1. Review the safety and ESD information at the beginning of this manual and in the appendices. 2. Identify the location within the rack where the server system is to be installed. 3. Install the rack mount rails as described in the rail installation instructions. 4. Remove the compute modules, hard drives, power supply modules, I/O modules, and cooling modules. 5. Working with at least two people, slide the server system into the rack so that it rests on the rack mounting rails. 6. Secure the server system in the rack as described in the rail installation instructions. 7. Install all compute modules, hard drives, power supply modules, I/O modules, and cooling modules. Hot-Swap Module Installation and Removal Guidelines • The green color on components and labels in your chassis identifies hot-swap components. You can install or remove hot-swap modules and hot-plug compute modules, with some restrictions, while the server system is powered on. • You do not need to disconnect the server system from power to install or replace any of the hot-swap modules; however, to avoid data corruption, you must shut down the operating system and power off the compute module before removing it from the server system. • Hot-swap cooling modules must be replaced within one minute. All other hot-swap and hot-plug components must be replaced within two minutes. Compute modules, management modules, switch modules, storage control modules, power modules, and cooling modules should be replaced with a like component or a filler panel within two minutes. Intel® Modular Server System User Guide 19