Invacare TER Owners Manual - Page 31

SECTION 4-BACK 12. Adjust the slack in the back upholstery cover and then secure to the seat pan fastening straps. Back Height Adjustment (Adjustable Backs Only) NOTE: For this procedure, refer to FIGURE 4.7 on page 31 NOTE: Observe the tautness of the back upholstery for reinstallation. 1. Unlatch the two fastening flaps that secure the top of the back upholstery to the back posts and remove from the back posts. ƽ WARNING Push pin MUST be protruding through hole in back post. Ensure that both back post inserts are at the same height BEFORE reassembling the wheelchair. 2. Press the push pin on the back post insert tube in and adjust the back height to one of four heights depending on original back height: ORIGINAL BACK 9-11 10-14 12-16 HEIGHT (22.86 - 27.94 CM) (25.40 - 35.56 CM) (30.48 - 40.64 CM) (IN INCHES) 14 - 18 (35.56 - 45.72 CM) 16 - 20 (40.64 - 50.8 CM) Hole* Number 1 9 (22.86 cm) 10 (25.40 cm) 12 (30.48 cm) 14 (35.56 cm) 16 (40.64 cm) 2 10 (25.40 cm) 11 (27.94 cm) 13 (33.02 cm) 15 (38.1 cm) 17 (43.18 cm) 3 11 (27.94 cm) 12 (30.48 cm) 14 (35.56 cm) 16 (40.64 cm) 18 (45.72 cm) 4 N/A 13 (33.02 cm) 15 (38.10cm) 17 (43.18 cm) 19 (48.25 cm) 5 N/A 14 (35.56 cm) 16 (40.64 cm) 18 (45.72 cm) 20 (50.8 cm) *NOTE: Holes numbered from bottom to top for reference only. (There are no numbers on the back posts.) NOTE: There is a 1‐inch (2.54 cm) adjustment pin on the back post insert tube. To raise back to maximum height, first make adjustment to the back post inserts. 3. Reinstall the fastening flaps onto the back posts. NOTE: The fastening flap with logo is for the left back post. NOTE: Right and left is determined by sitting in the wheelchair. 4. Adjust the new back upholstery to the desired tautness. Refer to Adjustable Tension Back Upholstery on page 29. Insert Back Post Hole Number 5 4 3 2 1 Part No 1122172 FIGURE 4.7 Back Height Adjustment (Adjustable Backs Only) 31 Everyday Series Wheelchairs/Sport Series Wheelchairs