Invacare TER Owners Manual - Page 38

SECTION 5-WHEELS Stop - Not touching camber clamp Adjustment Ring Camber Clamp Stop - In position for one camber, touching camber clamp Adjustment Ring Camber Clamp Stop - In position for one camber, touching camber clamp Adjustment Ring Adjustment Ring Stop - Not touching camber clamp FIGURE 5.11 Adjusting Toe In/Toe Out - Adjustable Camber System - Course Adjustment NOTE: DO NOT tighten the phillips screw on the other adjustment ring at this time. NOTE: Repeat STEPS 1‐7 of this procedure for the other adjustment ring after repositioning the camber insert. Refer to Adjusting Rear Wheel Camber on page 35. NOTE: When positioning the other adjustment ring, rotate the ring until the stop is at the bottom of the slot in the camber clamp. The right and left stops MUST be positioned opposite to each other or Fine Adjustment on page 38 will not work correctly. NOTE: When the left adjustment ring is adjusted to a camber, the right adjustment ring will not touch the camber clamp and when the right adjustment ring is adjusted to the other camber the left adjustment ring will not touch the camber clamp. Fine Adjustment NOTE: For this procedure, refer to FIGURE 5.12 and FIGURE 5.13 on page 39. NOTE: This adjustment is required anytime the camber insert is repositioned. 1. Open the camber clamp. Refer to Opening/Closing Camber Clamps on page 34. 2. Slowly rotate the axle tube until the stop on the opposite adjustment ring is positioned at the opposite end of the camber clamp. 3. Close the camber clamp. Refer to Opening/Closing Camber Clamps on page 34. NOTE: Rear wheels are removed from the drawings for clarity, there is no need to remove rear wheels from the wheelchair during adjustment. NOTE: FIGURE 5.13 shows one example of how the adjustment rings can be positioned. Axle Tube - Rotates Up and Down FIGURE 5.12 Adjustable Camber System Everyday Series Wheelchairs/Sport Series Wheelchairs 38 Part No 1122172