Invacare TER Owners Manual - Page 54
Replacing/Adjusting Optional Adjustable Angle One Piece Footplate
View all Invacare TER manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
SECTION 7-FOOTREST/ANTI-TIPPER Installing 1. Install the two half clamps onto either side of the wheelchair frame approximately 2‐inches (5.08 cm) above existing footrest with two provided allen screws. 2. Repeat for the opposite side of the wheelchair. 3. Slide the clamp on raised footrest into the half clamps to the desired height. 4. Securely tighten the four allen screws. Wheelchair Frame Half Clamp Allen Screws Raised Footrest Outside Footrest Hoop FIGURE 7.2 Installing/Adjusting Optional Clamp on Raised Footrest Adjusting 1. Loosen the four allen screws. 2. Adjust clamp on raised footrest to the desired height. 3. Securely tighten the four allen screws. Replacing/Adjusting Optional Adjustable Angle One Piece Footplate NOTE: For this procedure, refer to FIGURE 7.3 on page 54. NOTE: This procedure is for Terminator Everyday (ED) wheelchairs Only. Replacing the Footrest 1. Loosen, but DO NOT remove the two allen screws that secure the footrest to the wheelchair frame. 2. Slide the existing footrest tubes out of the wheelchair frame and install new footrest by reversing this step. 3. Position the new footrest to a determined height. 4. Tighten the two allen screws that secure the footrest to the wheelchair frame. 5. Adjust the footplate to the desired position. Refer to Adjusting Footplate Angle on page 54 and/or Adjusting Footplate Depth on page 54. Allen Screws Footrest Tube Height Angle Flat Screws Footpla Depth Flat Screws FIGURE 7.3 Replacing/Adjusting Optional Adjustable Angle One Piece Footplate Adjusting Footplate Angle 1. Loosen, but DO NOT remove the four flat screws and locknuts that secure the footplate to the two footrest tubes. 2. Position the footplate to the necessary angle to accommodate the user. 3. Retighten the four flat screws and locknuts. NOTE: The locknuts should lie in the channel of the footplate half clamp. Adjusting Footplate Depth 1. Loosen, but DO NOT remove the four flat screws and locknuts that secure footplate to the footrest tubes. NOTE: Observe the angle of footplate for reinstallation. 2. Move the footplate to one of two positions to accommodate the user. 3. Retighten the four flat screws and locknuts. NOTE: The settings for positioning the footplates on the half‐clamps may vary for each end user. NOTE: The locknuts should lie in the channel of the footplate half clamp. Everyday Series Wheelchairs/Sport Series Wheelchairs 54 Part No 1122172