Invacare TER Owners Manual - Page 46
Replacing/Adjusting Castors
View all Invacare TER manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
SECTION 5-WHEELS 12. Close the left camber clamp. Refer to Opening/Closing Camber Clamps on page 34. 13. Rotate the right toe adjustment ring until the tab stops against the upper metal tab on the camber clamp. 14. Securely tighten set screw on right toe adjustment ring. 15. Repeat STEP 7. 16. Perform one of the following: • Toe In/Toe Out Measurement is Within ±1/8‐inch (.32 cm) ‐ i. Proceed to STEP 17. • Toe In/Toe Out Measurement is Not Within ±1/8‐inch (.32 cm) ‐ i. Repeat STEP 1. ii. Loosen the set screw on the right toe adjustment ring. iii. Repeat STEP 3. iv. Repeat STEPS 12‐16 until toe in/toe out measurement is within ±1/8 (.32 cm) inch. 17. If desired, reposition camber inserts to the desired degree of camber. Refer to Adjusting Rear Wheel Camber on page 35. Flat Edge of Camber Tube Place "L" Square Here 90° Angle Ground/Floor Lower Degree of Camber Left Tab Stopped Against Lower Edge of Camber Clamp Left Toe Adjustment Ring Camber Clamp Axle Tube - Will Rotate Up only Higher Degree of Camber Axle Tube - Will Rotate Down only Right Toe Adjustment Ring Right Tab Stopped Against Upper Edge of Camber Clamp Camber Clamp FIGURE 5.21 Adjusting the Axle Tube - Adjustable Camber System Replacing/Adjusting Castors CAUTION Changing the size/type of and/or repositioning the front castors can affect the performance of the wheelchair. Contact Invacare at the telephone numbers on the back of this manual before performing this procedure. NOTE: For this procedure, refer to FIGURE 5.22 on page 47. NOTE: Non‐suspension castors cannot be adjusted as they mount in one position only. Everyday Series Wheelchairs/Sport Series Wheelchairs 46 Part No 1122172